5 6
Filter Maintenance
The filter cartridges in the AQUA2000 require periodic replacement for peak
performance.
CAUTION: Use only replacement filters provided by your AQUA2000
distributor. Contact your service center for replacement filters.
The filter should be replaced when it appears dirty and/or the normal flow of
water through the system has decreased.
The filter should be replaced when one or
more of the following occur:
• The filter has been in service for one year.
• The filter has processed more than 1000 gallons
of water.
• The system has not been activated for more
than two weeks.
• There is a noticeable decrease in water flow.
5. Reconnect the tubing by reinserting
the connector into the collar. Press
down on the tubing until the
connector is seated properly
.
6. Plug in the power supply, turn on the
system and allow water to flow
through the new filter for a minimum
of five (5) minutes before drinking
the water.
Please Note: If your AQUA2000 unit develops leakage
around the top cap, simply remove the cap, reseat the blue
o-ring (C), and carefully replace the cap (see step 4 above).
Changing the Filter
CAUTION: Unplug the system to prevent electrical
shock and potential exposure to UV light.
1. Remove the filter chamber cap (see page 6).
2. Remove the filter (B) and discard.
3. Install the new filter (B).
4. Replace the top cap (A) making sure the
o-ring (C) is seated properly in the chamber
when the cap is tightened. Make sure to hold the
chamber securely with one hand while you
tighten its cap with your other hand.
Changing the UV Lamp
It is recommended that you contact your authorized AQUA2000 distributor to
replace the UV lamp when it is no longer working, or every two years.
WARNING: To prevent electrical shock, unplug the power supply from the
electrical outlet. DO NO
T PR
OCEED BEFORE MAKING SURE THERE IS
NO ELECTRICITY GOING TO THE SYSTEM.
1. Disconnect the tubing from the top and bottom of the system. Remove the
unit from the wall mounts if applicable. Lay the system down horizontally.
2. Using a Phillips head screwdriver, remove the four
screws located on the bottom of the unit.
3. Slide the bottom cup off the unit.
4. Remove the screw (A) and the retainer wire (B)
5. Disconnect the two wire connectors (C) and (D)
coming from the lamp and gently slide the lamp out
of the system.
6. Carefully slide the replacement UV lamp into the
system holding it by the ceramic base only. Reconnect
the two wire connectors (C) and (D).
7. Reinstall the retainer wire (B) back into its original position
and tighten screw (A).
8. Replace the bottom cup and secure with screws. Do not overtighten screws.
9. Remount the system, reconnect the tubing and plug in the power adapter.
If the lamp does not illuminate, contact your authorized local service center. Do
not use the system until the lamp is functioning properly. You can find your local
service center by visiting www.rppurchase.com or by calling 1-866-786-8946.
Removing the Filter Cap(s)
Maintaining your AQUA2000 will require the
removal of the filter chamber caps. To remove
a cap, disconnect the tubing by pressing down
on the connector collar using the included tool
while pulling up on the tubing. Once the
tubing is disconnected, hold each chamber
securely with one hand while you unscrew its
cap with your other hand.
B-6280 BR7242R-1 9/8/06 2:23 PM Page 6
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels